Search found 415 matches

by Mark
Tue Aug 06, 2013 12:47 pm
Forum: Beta Testers
Topic: Initial overnight tests
Replies: 5
Views: 3916

Re: Initial overnight tests

I've got high hopes for the results that we'll get with the inflection termination method - from all of the charging graphs that I've seen, it should work reliably even on cells that don't show a voltage drop and also at low charging rates. I suspect that the reason why we haven't seen it being used...
by Mark
Tue Aug 06, 2013 12:42 pm
Forum: Beta Testers
Topic: Eneloop Charge Graph
Replies: 2
Views: 2639

Re: Eneloop Charge Graph

Yep - hopefully it works as I expect. Being able to measure both voltage and current with the 18 bit ADC should give this charger a huge advantage over all of the other chargers! I've also got an iCharger 206B - it's clear from looking at the graphs that it produces that it's only got a 10 bit ADC o...
by Mark
Mon Aug 05, 2013 3:37 am
Forum: Beta Testers
Topic: Initial overnight tests
Replies: 5
Views: 3916

Re: Initial overnight tests

Looks like both batteries terminated on maximum temperature which isn't ideal - that can be because the cells have gone high impedance which creates more heat. The first cell terminated after only 28 minutes, so it would be nowhere near a full charge if it started flat, and it looks like it was pret...
by Mark
Sun Aug 04, 2013 7:31 pm
Forum: Beta Testers
Topic: Initial overnight tests
Replies: 5
Views: 3916

Re: Initial overnight tests

All, In my current test setup, with an Energizer in position 1 and a Duracell in position 2 (SD card insertion side) I did get it to run overnight in 'cycle' mode. I tried one more time to get the serial output to show up correctly after our '8MHz vs. 16 MHz' discussion, and somehow it worked. It s...
by Mark
Mon Jul 29, 2013 1:16 pm
Forum: Beta Testers
Topic: Eneloop Charge Graph
Replies: 2
Views: 2639

Eneloop Charge Graph

I've just completed charging a couple of Eneloops with my latest code. I've now included a pause every 5 seconds to check the cell voltage without current being applied. Paul is correct in that it does give a better signal. The loaded voltage is now noisier because the voltage drops a bit during the...

Go to advanced search